Fisher Paykel CMOH-30SS Installationshandbuch PDF herunterladen

Please read all instructions thoroughly before installing the Over the Range Microwave Oven/Hood

System. Two people are recommended to install this product.

If a new electrical outlet is required, its installation should be completed by a qualied electrician before

the microwave oven is installed. See 3 ELECTRICAL GROUNDING INSTRUCTIONS on page 2.

1. MOUNTING SPACE

This Microwave Oven/Hood requires a mounting space on a wall

as shown in Figure 1.

For proper installation and servicing, a 2-inch space is necessary

between the top of the range backsplash and the bottom of the

Microwave Oven/Hood system.

2. WALL CONSTRUCTION

This Microwave Oven/Hood should be mounted against and

supported by a at vertical wall. The wall must be at for proper

installation. If the wall is not at, use spacers to ll in the gaps.

Wall construction should be a minimum of 2" x 4" wood studding

and 3/8" or more thick dry wall or plaster/lath. The mounting

surfaces must be capable of supporting weight of 110 pounds—

the oven and contents—AND the weight of all items which would

normally be stored in the top cabinet above the unit.

The unit should be attached to a minimum of one 2" x 4" wall

stud.

To nd the location of the studs, one of the following methods

may be used:

A. Use a stud nder, a magnetic device which locates the nails in

the stud.

B. Use a hammer to tap lightly across the mounting surface to nd

a solid sound. This will indicate stud location.

The center of the stud can be located by probing the wall with a

small nail to nd the edges of the stud and then placing a mark

halfway between the edges. The center of any adjacent studs will

normally be 16" or 24" to either side of this mark.

Note: In the event that the unit will be unable to be supported by

any stud, it will be necessary to use special care in the placement

of the toggle bolts and top cabinet screws. See Wall Template for

details. The top cabinet should be tested to ensure it is securely

attached to the wall. Place extra weight up to 110 pounds inside

the top cabinet to test the support.

OVER THE RANGE CONVECTION MICROWAVE OVEN

INSTALLATION INSTRUCTIONS

Figure 1

Figure 2

2"x 4"

Wood Studs

3/8" Dry Wall

or Plaster/lath

16" or 24"

Backsplash

36" or more

from cooking

surface

72" or more

from oor

15.5"

30"

12"

Minimum 2"

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - INSTALLATION INSTRUCTIONS

1Please read all instructions thoroughly before installing the Over the Range Microwave Oven/Hood System. Two people are recommended to install this p

Seite 2 - 4. HOOD EXHAUST DUCT

2 3. ELECTRICAL GROUNDING INSTRUCTIONSThis appliance must be grounded. This microwave oven is equipped with a cord having a grounding wire with a grou

Seite 3 - 7. PREPARATION OF THE OVEN

35. TOOLS RECOMMENDED FOR INSTALLATION• PhillipsScrewdriver • 1-1/2"WoodBitorMetalHoleCutter(ifmetalcabinetisused)• ElectricDrill

Seite 4 - 8. VENTILATION SYSTEM

4 8. VENTILATION SYSTEMThis Microwave Oven/Hood System is designed for adapta-tion to three types of hood ventilation systems. Select the conguration

Seite 5

5C. Vertical Exhaust — Outside Ventilation1. Remove and save the 4 screws from the Fan Cover Bracket. Remove Fan Cover Bracket by sliding it in the o

Seite 6 - 9. OVEN INSTALLATION

6 9. OVEN INSTALLATIONTHIS MICROWAVE OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON BOTH TEMPLATES.READ AND

Seite 7 - MOUNTING OVEN TO THE WALL

7MOUNTING OVEN TO THE WALLTwo people are recommended to attach the Microwave Oven/Hood to the Mounting Plate.1. Thread the power supply cord through

Seite 8 - CHECKLIST FOR INSTALLATION

MOUNTING DEFLECTORSecure the deector with 3 Tapping screws 4 x 12 mm, packed in the Installation Hardware.DeectorCHECKLIST FOR INSTALLATION1. Make